Question 1
1 markA steelworks rolls hot steel into plates about 10 mm thick. A radioactive source on one side of the plate and a detector on the other side are used to check the thickness of each plate as it is made.
Each source below emits only the type of radiation shown.
Which source is most suitable?
Choose your answer.
- A beta emitter, half-life 29 years
- B gamma emitter, half-life 6 hours
- C gamma emitter, half-life 30 years
- D alpha emitter, half-life 430 years
Model answer
C - gamma emitter, half-life 30 years.
Explanation
A thickness gauge needs radiation that is partly, but not completely, absorbed by the material, so that a change in thickness gives a measurable change in count rate. For thin materials such as paper or plastic film this is beta, but beta particles cannot pass through 10 mm of steel, so gamma is used. A long half-life means that any change in the count rate is caused by the thickness, not by the source decaying.
Mark scheme
-
1 mark
C / gamma emitter, half-life 30 years (1)
The only correct answer is C: gamma rays are only partly absorbed by 10 mm of steel, so the count rate measured by the detector changes when the thickness of the plate changes, and with a half-life of 30 years the count rate does not fall noticeably because of decay while the gauge is in use. A is not correct because beta particles would be completely absorbed by 10 mm of steel, so the detector would record only background radiation whatever the thickness; B is not correct because with a half-life of 6 hours the count rate would halve every 6 hours even if the thickness did not change, so the readings would be misleading and the source would need replacing very often; D is not correct because alpha particles would be absorbed by the steel (and by a few centimetres of air), so none would reach the detector. Accept the letter or the option. If more than one option is given, do not award the mark.