Level:
Correct: 0
Incorrect: 0
Marks: 0/0
Exam Practice
Course:
Topics:
OCR GCSE Physics (Paper 4) Smart practice A mixed round aimed at your weak spots
Unit 5
Waves in matter
Unit 6
Radioactivity
Unit 7
Energy
Unit 8
Global challenges
Unit 9
Practical skills
Avg
score:
–
Topics
done:
0/33

Electromagnetic waves in circuits and materials

Practise 16 exam-style questions on Electromagnetic waves in circuits and materials for OCR GCSE Physics (Paper 4). Write your answer as you would in the exam and get it marked in seconds against the mark scheme, point by point, with the Study Helper on hand if you get stuck.

  • 16 questions
  • 1–6 marks each
  • Instant marking
  • No sign-up needed
16 questions, marked as you go

Sample questions with model answers

Here are 4 of the questions in this topic, each with a model answer, an explanation of why it earns the marks and the mark scheme an examiner would use.

Question 1

1 mark

Green light has a frequency of 6.0 × 10¹⁴ Hz. In air its wavelength is 500 nm.

The light enters a glass block, where its speed is 2.0 × 10⁸ m/s. Its frequency does not change.

What is the wavelength of the light in the glass?

Choose your answer.

  • A 33 nm
  • B 333 nm
  • C 500 nm
  • D 750 nm

Model answer

B

Explanation

The frequency is fixed by the source, so when light slows down in glass its wavelength must become shorter in proportion: wavelength = speed ÷ frequency = 2.0 × 10⁸ ÷ 6.0 × 10¹⁴ = 3.33 × 10⁻⁷ m = 333 nm. A quick check: the speed falls to two-thirds of 3.0 × 10⁸ m/s, so the wavelength falls to two-thirds of 500 nm. Students who multiply by 1.5 instead get 750 nm.

Mark scheme
  1. 1 mark

    B / 333 nm

    The only correct answer is B: wavelength = wave speed ÷ frequency = 2.0 × 10⁸ ÷ 6.0 × 10¹⁴ = 3.33 × 10⁻⁷ m = 333 nm (the light slows down, so its wavelength becomes shorter). A is not correct because it comes from a power-of-ten slip when converting 3.33 × 10⁻⁷ m into nanometres; C is not correct because the wavelength does change when the speed changes (only the frequency stays the same); D is not correct because the wavelength becomes shorter, not longer, when the light slows down (750 nm is 500 nm × 1.5). ALLOW the letter or the option. If more than one option is given, do not award the mark.

Question 2

2 marks

Messages are sent to submarines just below the surface of the sea using radio waves with very long wavelengths, of 10 km or more. Microwaves cannot be used to send messages to the submarines.

Explain why.

Model answer

Sea water absorbs microwaves very strongly, so they are absorbed close to the surface and do not reach the submarine. Radio waves with very long wavelengths are absorbed much less by sea water, so they are transmitted far enough into the water to reach a submarine just below the surface.

Explanation

The same substance can absorb electromagnetic waves of one wavelength strongly and transmit waves of another wavelength. Sea water absorbs short-wavelength radiation such as microwaves within a very short distance, but very long-wavelength radio waves can travel a few metres into it. This is why a submarine must be close to the surface to receive messages.

Mark scheme
  1. 1 mark

    sea water absorbs microwaves (short wavelengths) strongly, so they do not reach the submarine / are not transmitted far into the water

    ALLOW microwaves are absorbed in the first few millimetres / centimetres of sea water. ALLOW microwaves are reflected at the surface of the sea. IGNORE 'microwaves cannot travel through water' without the idea of absorption or reflection by the water.

  2. 1 mark

    very long wavelength radio waves are absorbed less by sea water, so they are transmitted some distance into the water / reach the submarine

    ALLOW the amount of absorption depends on the wavelength / longer wavelengths pass further through water. ORA (allow the reverse argument).

Question 3

3 marks

An old electric drill has a worn motor that makes tiny sparks inside it. Each spark causes a rapidly oscillating current in the drill's wires for a very short time.

When the drill is used near a radio, crackling noises come from the radio's loudspeaker.

Explain why.

Model answer

Each spark makes the current in the drill's wires oscillate very rapidly, and an oscillating current in a wire produces radio waves. These radio waves travel to the radio and are absorbed by its aerial. There they induce oscillations of the electrons, an alternating current, in the aerial and the radio's circuit. The radio amplifies this unwanted signal along with the station, and it is heard as crackling from the loudspeaker.

Explanation

This question uses both halves of the same idea: oscillations in a circuit produce radio waves, and radio waves induce oscillations in another circuit. The drill acts as an unwanted transmitter and the radio as the receiver. Answers that say electricity or sparks travel to the radio miss the point that energy is carried by electromagnetic waves.

Mark scheme
  1. 1 mark

    the oscillating current in the drill (wires) produces radio waves / electromagnetic waves

    ALLOW the drill's wires act as a transmitting aerial. ALLOW the sparks give out radio waves. IGNORE sound waves from the drill.

  2. 1 mark

    the radio waves travel to the radio and are absorbed by its aerial (or circuit)

    ALLOW the radio picks up / receives the radio waves from the drill.

  3. 1 mark

    the radio waves induce oscillations / an alternating current in the radio's aerial / circuit, which the radio turns into the crackling sound

    ALLOW the waves make electrons in the radio's aerial oscillate, giving an extra signal that is heard as crackling. DO NOT ALLOW the sparks travel to the radio / electricity jumps to the radio.

Question 4

4 marks

A satnav receiver works out its distance from a satellite by timing how long a microwave signal takes to travel from the satellite to the receiver. The receiver assumes that the signal travels at 3.00 × 10⁸ m/s all the way.

One signal takes 0.0700 s to arrive.

Calculate the distance from the satellite that the receiver works out.

In the lower atmosphere the microwaves travel slightly more slowly than 3.00 × 10⁸ m/s. Explain whether the distance worked out by the receiver is too large or too small.

Model answer

Distance = speed × time = 3.00 × 10⁸ × 0.0700 = 2.10 × 10⁷ m (21 000 km)

In the atmosphere the signal travels more slowly than the receiver assumes, so it takes longer to arrive. The receiver multiplies this longer time by the full speed, so the distance it works out is too large: the satellite is really slightly closer.

Explanation

The calculation uses distance = speed × time. The second part is about the effect of a change in the speed of electromagnetic waves in a different substance: the microwaves slow down in the air, so the signal arrives late, and a receiver that assumes the full speed overestimates the distance. Real satnav systems correct for this delay, otherwise positions could be wrong by several metres.

Mark scheme
  1. 1 mark

    distance = speed × time = 3.00 × 10⁸ × 0.0700; or a correct final answer of 2.10 × 10⁷ m with no working

    An answer of 2.10 × 10⁷ m with no working scores marking points 1 and 2. ALLOW 21 000 000 m / 21 000 km / 2.1 × 10⁷ m. ALLOW distance = speed × time recalled in any form.

  2. 1 mark

    evaluation: 2.10 × 10⁷ (m) / 21 000 km

    ALLOW 21 000 only if the unit given is km. Otherwise IGNORE units.

  3. 1 mark

    the signal travels more slowly through the atmosphere, so it takes longer to arrive than it would at full speed

    ALLOW the time measured is longer than the time the signal would take at the speed the receiver assumes.

  4. 1 mark

    so the distance worked out (speed × the longer time) is too large / greater than the real distance

    This mark needs a reason linked to the longer time or the slower speed. DO NOT ALLOW too small.

Ready to try the rest? Every answer you write is marked against the mark scheme, so you can see exactly where the marks are.

Study Helper Hints first, answers after you try

Stuck on this one? Ask for a hint and I’ll point you in the right direction, without giving the answer away. Once you’ve checked your answer, I’ll show you how the marks are awarded.