Level:
Correct: 0
Incorrect: 0
Marks: 0/0
Exam Practice
Course:
Topics:
OCR GCSE Physics (Paper 3) Smart practice A mixed round aimed at your weak spots
Unit 1
Matter
Unit 2
Forces
Unit 3
Electricity
Unit 4
Magnetism and magnetic fields
Unit 9
Practical skills
Avg
score:
–
Topics
done:
0/36

The Earth's atmosphere and atmospheric pressure

Practise 10 exam-style questions on The Earth's atmosphere and atmospheric pressure for OCR GCSE Physics (Paper 3). Write your answer as you would in the exam and get it marked in seconds against the mark scheme, point by point, with the Study Helper on hand if you get stuck.

  • 10 questions
  • 1–6 marks each
  • Instant marking
  • No sign-up needed
10 questions, marked as you go

Sample questions with model answers

Here are 4 of the questions in this topic, each with a model answer, an explanation of why it earns the marks and the mark scheme an examiner would use.

Question 1

1 mark

A simple model of the Earth's atmosphere assumes that the air has the same density at all heights, up to a top edge.

Which statement describes how atmospheric pressure changes with height in this model?

Choose your answer.

  • A It decreases by the same amount for each metre of height, and is zero at the top edge.
  • B It decreases by a smaller amount for each metre of height, and never reaches zero.
  • C It increases with height, because the air higher up is less squashed.
  • D It stays the same at all heights, and then falls to zero at the top edge.

Model answer

A

Explanation

With uniform density, the weight of air above each square metre falls by the same amount for every metre you go up, so a graph of pressure against height in this model is a straight line that reaches zero at the top of the atmosphere. In the real atmosphere the density decreases with height, so the pressure falls more slowly higher up.

Mark scheme
  1. 1 mark

    A / it decreases by the same amount for each metre of height, and is zero at the top edge

    The only correct answer is A: if the density is the same at all heights, each metre of height contains the same mass of air above each square metre, so going up 1 m always removes the same weight of air from above and the pressure falls by the same amount; at the top edge there is no air above, so the pressure is zero. B is not correct because it describes the real atmosphere, in which the air higher up is less dense; C is not correct because atmospheric pressure decreases with height, as there is less air above; D is not correct because there is less air above a point the higher it is, so the pressure cannot stay the same. ALLOW the letter or the option. If more than one option is given, do not award the mark.

Question 2

2 marks

A student uses a simple model of the atmosphere in which the air has a uniform density of 1.2 kg/m³ at all heights. She uses it to predict the decrease in atmospheric pressure:
• from the bottom to the top of a hill 150 m high: the model predicts a decrease of 1.8 kPa
• from sea level to the top of Mount Everest, 8850 m high: the model predicts a decrease of 106 kPa.

Atmospheric pressure at sea level is about 101 kPa. The measured pressure at the top of Mount Everest is about 34 kPa.

Explain why the model gives a good prediction for the hill but not for Mount Everest.

Model answer

Over a small height such as 150 m, the density of the air hardly changes, so assuming a uniform density of 1.2 kg/m³ is reasonable and the prediction is good. But air is a gas, so the air high up is much less compressed than the air near the ground and its density is much smaller. Over 8850 m there is much less air above each square metre than the model assumes, so the model predicts too big a drop: 106 kPa is more than the whole sea-level pressure, but the real drop is only about 101 − 34 = 67 kPa.

Explanation

A model is only as good as its assumptions. Assuming uniform density works when the density hardly changes, over heights of a few hundred metres, but not over many kilometres, because the real air becomes much less dense with height. The model's prediction of a drop larger than the whole atmospheric pressure shows it has broken down.

Mark scheme
  1. 1 mark

    over a small height (such as 150 m) the density of the air changes very little, so assuming a uniform density is reasonable (and the prediction is accurate)

    ALLOW the reverse argument. ALLOW the air near the ground has a density close to 1.2 kg/m³.

  2. 1 mark

    air is compressible / the air higher up is less compressed, so its density decreases a lot over 8850 m; there is less air above each square metre than the model assumes, so the model predicts too large a decrease (106 kPa is more than the whole pressure at sea level / the real decrease is only about 67 kPa)

    The idea that the density of the air decreases with height is needed. ALLOW 'the model would give a negative pressure at the top of Everest' in place of the comparison in brackets. IGNORE changes in temperature on their own.

Question 3

3 marks

A teacher puts a small amount of water into an empty metal drinks can and heats it until the water boils. Steam fills the can and pushes out most of the air. The teacher then quickly turns the can upside down and dips its open end into a bowl of cold water. The can is crushed with a loud bang.

A student says: 'The can was crushed because the steam inside sucked the walls of the can inwards.'

Explain why the can is crushed. Your answer should explain why the student is wrong.

Model answer

When the can is dipped into the cold water, the steam inside cools and condenses into water. Very few gas particles are left inside, so the pressure inside the can falls to much less than atmospheric pressure. The air outside now pushes on the outside of the can with a much greater force than the gas inside pushes outwards, so there is a large net force inwards, at right angles to every part of the walls. The can is pushed in by the atmosphere. The student is wrong because nothing sucks or pulls the walls: there is no 'suction' force, only the push of the air outside, which is no longer balanced by a push from inside.

Explanation

Atmospheric pressure acts on every surface, but normally it is balanced by the gas inside a container. When the steam condenses, the balance is lost and the push of the air outside crushes the can. 'Suction' is a common misconception: a low pressure cannot pull anything; the higher pressure on the other side pushes.

Mark scheme
  1. 1 mark

    the steam (cools and) condenses to water, so there are far fewer gas particles inside the can / the pressure inside the can falls (to much less than atmospheric pressure)

    ALLOW the steam turns back into a liquid, so the pressure inside drops. IGNORE the steam contracts unless it is linked to a fall in pressure.

  2. 1 mark

    atmospheric pressure outside the can is now much greater than the pressure inside / the air particles outside hit the outside of the can much more often than the gas particles inside hit the inside

    ALLOW the air pressure outside is bigger than inside.

  3. 1 mark

    so there is a (large) net (resultant) force inwards, at right angles to the walls, from the air outside: the can is pushed in by the atmosphere, not sucked or pulled in by the steam

    The idea that the air outside pushes the walls in is needed for this mark. DO NOT ALLOW the low pressure inside sucks or pulls the walls in.

Question 4

5 marks

A passenger aircraft cruises at a height of 11 km. At this height, the atmospheric pressure outside the aircraft is 23 kPa. The air inside the cabin is kept at a pressure of 75 kPa.

One cabin window has an area of 0.080 m².

Calculate the resultant force on the window due to the pressures of the air inside and outside, and give its direction.

Explain why the atmospheric pressure at a height of 11 km is much lower than at the ground.

Model answer

pressure difference = 75 − 23 = 52 kPa = 52 000 Pa
pressure = force ÷ area, so force = pressure × area
force = 52 000 × 0.080 = 4160 N
The resultant force acts outwards, away from the cabin, at right angles to the window.
The pressure at 11 km is much lower because there is much less air above that height, so the weight of air above each square metre is much smaller than at the ground.

Explanation

The air on each side pushes on the window at right angles to it, so the resultant force comes from the difference between the two pressures, multiplied by the area. Convert kPa to Pa before multiplying by an area in m². Atmospheric pressure is caused by the weight of the air above, so it is lower high up where there is less air above.

Mark scheme
  1. 1 mark

    recall: pressure = force ÷ area / force = pressure × area; or a correct final answer of 4160 N / 4200 N with no working

    An answer of 4160 N (ALLOW 4200 N) with no working scores marking points 1, 2 and 3. ALLOW 1 mark for 6000 N or 1840 N (only one of the pressures used). ALLOW 2 marks for 4.16 N or 4.2 N (the pressure difference left in kPa). ALLOW p = F ÷ A or F = p × A.

  2. 1 mark

    substitution: (75 000 − 23 000) × 0.080 / 52 000 × 0.080; or a correct final answer of 4160 N / 4200 N with no working

    ALLOW 75 000 × 0.080 − 23 000 × 0.080 (6000 − 1840).

  3. 1 mark

    evaluation: 4160 (N)

    ALLOW 4200 N or 4.16 kN.

  4. 1 mark

    (the force acts) outwards / away from the cabin / out of the aircraft (at right angles to the window)

    The idea of outwards is needed. ALLOW perpendicular or normal to the window, outwards. At right angles to the window on its own does not score. DO NOT ALLOW inwards.

  5. 1 mark

    there is less air above the aircraft's cruising height (than above the ground) / a smaller weight of air above each square metre, so the pressure is lower

    ALLOW fewer air particles above. IGNORE density or gravity on their own. ALLOW the reverse argument for the ground.

Ready to try the rest? Every answer you write is marked against the mark scheme, so you can see exactly where the marks are.

Study Helper Hints first, answers after you try

Stuck on this one? Ask for a hint and I’ll point you in the right direction, without giving the answer away. Once you’ve checked your answer, I’ll show you how the marks are awarded.