Level:
Correct: 0
Incorrect: 0
Marks: 0/0
Exam Practice
Course:
Topics:
OCR GCSE Physics (Paper 3) Smart practice A mixed round aimed at your weak spots
Unit 1
Matter
Unit 2
Forces
Unit 3
Electricity
Unit 4
Magnetism and magnetic fields
Unit 9
Practical skills
Avg
score:
–
Topics
done:
0/36

Microphones and loudspeakers

Practise 8 exam-style questions on Microphones and loudspeakers for OCR GCSE Physics (Paper 3). Write your answer as you would in the exam and get it marked in seconds against the mark scheme, point by point, with the Study Helper on hand if you get stuck.

  • 8 questions
  • 1–4 marks each
  • Instant marking
  • No sign-up needed
8 questions, marked as you go

Sample questions with model answers

Here are 4 of the questions in this topic, each with a model answer, an explanation of why it earns the marks and the mark scheme an examiner would use.

Question 1

1 mark

A moving-coil microphone has a coil attached to a thin diaphragm. The coil sits in the magnetic field of a permanent magnet. The microphone is dropped, and afterwards it produces no current at all when sound reaches it.

Which fault would stop the microphone producing any current?

Choose your answer.

  • A The diaphragm has become stiffer, so it moves less.
  • B The magnet has become weaker.
  • C Some turns of the coil touch each other, so fewer turns are working.
  • D The coil has become stuck to the magnet, so it cannot move.

Model answer

D (if the coil cannot move relative to the magnet, the field through it does not change, so no p.d. is induced)

Explanation

A moving-coil microphone works by electromagnetic induction: the sound moves the coil in the magnet's field, so the field through the coil changes and a p.d. is induced. Faults A, B and C make the microphone less sensitive, because they reduce the induced p.d., but only D removes the changing field completely. A common error is to choose B, but a weaker magnet still has a magnetic field.

Mark scheme
  1. 1 mark

    D / the coil has become stuck to the magnet, so it cannot move

    The only correct answer is D: a p.d. is induced only when the magnetic field through the coil changes, which needs the coil to move relative to the magnet; a coil stuck to the magnet cannot move, so the field through it never changes and no p.d. or current is induced. A is not correct because a stiffer diaphragm still moves a little, so a smaller current is still produced; B is not correct because a weaker magnet still gives a changing field through the moving coil, so a smaller current is still produced; C is not correct because a p.d. is still induced in the turns that are working, so a smaller current is still produced. ALLOW the letter or the option. If more than one option is given, do not award the mark.

Question 2

2 marks

A student makes a simple loudspeaker. She glues a small coil of insulated wire to the bottom of a paper cup, and holds a strong permanent magnet just below the coil. She connects the coil to a signal generator, which supplies an alternating current. A quiet sound comes from the cup.

Suggest two changes to the coil or the magnet that would make the sound louder, without changing the current in the coil.

Model answer

Use a coil with more turns of wire, so that more wire is in the magnetic field.
Use a stronger magnet, or move the magnet closer to the coil, so that the magnetic field at the coil is stronger.
Both changes give a larger force on the coil for the same current, so the cup vibrates with a larger amplitude.

Explanation

The cup moves because there is a force on the current-carrying coil in the magnet's field. With the current fixed, the force can be made larger by putting more wire in the field (more turns) or by making the field stronger (a stronger magnet or a smaller gap). A larger force makes the cup vibrate further, so the pressure variations in the air are larger and the sound is louder.

Mark scheme
  1. 1 mark

    use a coil with more turns (of wire)

    1 mark for each different change, max 2. ALLOW use more wire in the coil / a greater length of wire in the magnetic field. IGNORE increasing the current or turning up the signal generator (the question rules this out). IGNORE changes to the cup.

  2. 1 mark

    use a stronger magnet

    ALLOW use more magnets / a magnet with a stronger magnetic field.

  3. 1 mark

    move the magnet closer to the coil / put the coil where the magnetic field is stronger

    ALLOW place the coil in the gap between two magnet poles, so that the field is stronger and at right angles to the wire.

Question 3

3 marks

A ribbon microphone contains a very thin, light strip of aluminium foil, called the ribbon. The ribbon hangs between the poles of a strong magnet, at right angles to the magnetic field. Wires are connected to the two ends of the ribbon.

Explain how sound waves produce an alternating potential difference between the ends of the ribbon.

Suggest why the potential difference from a ribbon microphone is much smaller than the potential difference from a moving-coil microphone for the same sound.

Model answer

The pressure variations of the sound wave push the light ribbon backwards and forwards in the magnetic field. The ribbon is a conductor, so as it moves through the field a potential difference is induced between its ends. Each time the ribbon changes direction, the induced p.d. reverses, so the p.d. alternates in step with the sound.

The ribbon is a single conductor, like a coil with only one turn. A moving-coil microphone has a coil of many turns, and a p.d. is induced in every turn, so its total p.d. is much larger.

Explanation

A ribbon microphone is a dynamic microphone in which the moving conductor is a single strip rather than a coil. The induction is the same: a conductor moving in a magnetic field has a p.d. induced across its ends, reversing when the movement reverses. Because there is only one conductor rather than many turns, the p.d. is small, so these microphones need extra amplification. A common error is to say the sound itself carries the electrical signal.

Mark scheme
  1. 1 mark

    the pressure variations of the sound wave make the (light) ribbon vibrate / move backwards and forwards in the magnetic field

    ALLOW compressions and rarefactions push the ribbon one way and then the other.

  2. 1 mark

    the ribbon is a conductor moving through the magnetic field / the magnetic field around the ribbon changes, so a p.d. is induced between its ends, and the p.d. reverses each time the ribbon changes direction (so it alternates)

    ALLOW the ribbon cuts the field lines. The idea that the p.d. reverses as the ribbon changes direction is needed for this mark. ALLOW the p.d. alternates in step with the pressure variations.

  3. 1 mark

    the ribbon is a single conductor / acts like a coil of only one turn, while a moving-coil microphone has a coil of many turns, with a p.d. induced in each turn, so its total p.d. is much larger

    ALLOW the ribbon is a much shorter length of conductor in the field than the long wire of a coil. IGNORE aluminium has a higher resistance. DO NOT ALLOW the ribbon microphone has a weaker magnet (the question does not say so).

Question 4

4 marks

On some ships, the crew use sound-powered telephones, which still work if the ship's electricity supply fails. Each handset has a moving-coil microphone and a moving-coil earpiece, which works like a small loudspeaker. The microphone in one handset is connected by long wires to the earpiece in another handset. There is no battery or other power supply in the circuit.

Explain how a sailor's voice at one handset produces sound from the earpiece at the other handset.

Model answer

The sound waves from the sailor's voice are pressure variations. They push the microphone's diaphragm in and out, so the coil attached to it vibrates. The coil moves in the magnetic field of the permanent magnet, so the field through the coil changes and a potential difference is induced. This drives a varying current along the wires, which changes in the same pattern as the pressure variations.

In the earpiece, this varying current flows in a coil that is in the field of another magnet, so there is a force on the coil (the motor effect). The force changes in size and direction as the current changes, so the earpiece's coil and diaphragm vibrate in the same pattern, pushing on the air and producing pressure variations: a sound wave like the voice.

Explanation

A moving-coil microphone and a loudspeaker or earpiece work in opposite directions: the microphone uses electromagnetic induction to turn pressure variations into current variations, and the earpiece uses the force on a current-carrying coil in a magnetic field to turn current variations back into pressure variations. No battery is needed because the energy comes from the sound wave of the voice. A common error is to describe only one end of the system, or to say the sound travels along the wires.

Mark scheme
  1. 1 mark

    the pressure variations of the sound waves (from the voice) make the diaphragm and coil of the microphone vibrate / move backwards and forwards

    ALLOW compressions and rarefactions for pressure variations. ALLOW the sound pushes the diaphragm in and out.

  2. 1 mark

    the coil moves in the magnetic field of the (permanent) magnet, so the field through the coil changes, which induces a p.d. that drives a varying / alternating current through the wires (that varies in the same pattern as the pressure)

    ALLOW the coil cuts the field lines. ALLOW electromagnetic induction (in the microphone) produces a current. The idea of induction is needed: DO NOT ALLOW the sound wave is converted into current with no mechanism.

  3. 1 mark

    in the earpiece, the varying current in the coil is in the magnetic field of a magnet, so there is a force on the coil (the motor effect) that changes in size and direction as the current changes

    ALLOW the magnetic field of the current in the earpiece coil interacts with the field of the magnet. ALLOW the force reverses when the current reverses.

  4. 1 mark

    so the coil and diaphragm of the earpiece vibrate (in the same pattern), pushing on the air to produce pressure variations / a sound wave like the voice

    ALLOW the earpiece converts the current variations back into pressure variations. IGNORE references to energy unless linked to the correct mechanism.

Ready to try the rest? Every answer you write is marked against the mark scheme, so you can see exactly where the marks are.

Study Helper Hints first, answers after you try

Stuck on this one? Ask for a hint and I’ll point you in the right direction, without giving the answer away. Once you’ve checked your answer, I’ll show you how the marks are awarded.