Level:
Correct: 0
Incorrect: 0
Marks: 0/0
Exam Practice
Course:
Topics:
AQA GCSE Combined Science (Foundation Physics Paper 1) Smart practice A mixed round aimed at your weak spots
Unit 18
Energy
Energy changes in a system, and the ways energy is stored before and after such changes
Energy stores and systems, and changes in energy
Energy changes in systems
Power
Conservation and dissipation of energy
Energy transfers in a system and efficiency
National and global energy resources
National and global energy resources
Unit 19
Electricity
Unit 20
Particle model of matter
Changes of state and the particle model
Density of materials and changes of state
Particle model and pressure
Particle motion in gases
Unit 21
Atomic structure
Avg
score:
–
Topics
done:
0/17

Internal energy, specific heat capacity and specific latent heat

Practise 23 exam-style questions on Internal energy, specific heat capacity and specific latent heat for AQA GCSE Combined Science (Foundation Physics Paper 1). Write your answer as you would in the exam and get it marked in seconds against the mark scheme, point by point, with the Study Helper on hand if you get stuck.

  • 23 questions
  • 1–6 marks each
  • Instant marking
  • No sign-up needed
20 questions, marked as you go

Sample questions with model answers

Here are 4 of the questions in this topic, each with a model answer, an explanation of why it earns the marks and the mark scheme an examiner would use.

Question 1

1 mark

Two identical beakers each contain 0.50 kg of water at 20 °C. Heater P transfers 21 000 J of energy to the water in one beaker. Heater Q transfers 42 000 J of energy to the water in the other beaker. The temperature of the water heated by Q rises more.

Which factor causes the difference in the temperature rise?

Choose your answer.

  • The mass of the water
  • The type of material
  • The starting temperature
  • The energy input

Model answer

The energy input

Explanation

The temperature rise of a system depends on the mass of the substance heated, the type of material and the energy input. Both beakers hold the same mass of the same material, so the difference is caused by the energy input: heater Q transfers twice as much energy, so the temperature of its water rises twice as much. The starting temperature does not decide the size of the rise.

Mark scheme
  1. 1 mark

    The energy input

    If more than one option is given, 0 marks. The mass of the water, the type of material (water in both) and the starting temperature (20 °C) are the same in both beakers, so they cannot cause the difference.

Question 2

2 marks

When a system is heated and its temperature increases, the size of the temperature rise depends on the energy input to the system.

Give two other factors that the size of the temperature rise depends on.

Model answer

The mass of the substance heated and the type of material.

Explanation

The temperature rise depends on three things: the mass of the substance, the type of material and the energy input. The type of material matters because different materials have different specific heat capacities. The heating time and the power of the heater only change the energy input, which is given in the question.

Mark scheme
  1. 1 mark

    the mass (of the substance heated)

    List rule: each wrong or contradictory extra answer cancels a correct one. ignore volume / amount of substance unless linked to mass.

  2. 1 mark

    the type of material / the substance being heated

    allow (the) specific heat capacity (of the material). ignore the time of heating / the power of the heater (these are the energy input, given in the question). do not accept the starting temperature.

Question 3

3 marks

Ella leaves an electric kettle switched on after the water starts to boil. While the water boils, 678 000 J of energy is transferred to the water.

specific latent heat of vaporisation of water = 2 260 000 J/kg

Calculate the mass of water that turns into steam.

Use the equation:

thermal energy for a change of state = mass × specific latent heat

Give your answer in kg.

Model answer

678 000 = m × 2 260 000
m = 678 000 ÷ 2 260 000
m = 0.30 kg

Explanation

Substitute the values into E = m L and then rearrange to find the mass: divide the energy by the specific latent heat. An answer of 0.30 kg is a sensible amount of water for a kettle. Checking the size of the answer catches the common mistake of multiplying the two values.

Mark scheme
  1. 1 mark

    678 000 = m × 2 260 000

  2. 1 mark

    m = 678 000 ÷ 2 260 000

    allow a correct rearrangement before substitution, m = E ÷ L.

  3. 1 mark

    m = 0.30 (kg)

    allow 0.3 (kg). A correct answer with no working scores full marks. Full marks are not awarded for a correct final answer from incorrect working. Multiplying the two values (about 1.5 × 10¹²) scores 0 marks.

Question 4

4 marks

Two values for water are given below.

specific heat capacity of water = 4200 J/kg °C
specific latent heat of vaporisation of water = 2 260 000 J/kg

Compare the specific heat capacity of water with the specific latent heat of vaporisation of water.

Model answer

Both values are amounts of energy for 1 kg of water, and both describe energy that increases the internal energy of the water.
The specific heat capacity is the energy needed to raise the temperature of 1 kg of water by 1 °C, so it involves a temperature change and its unit is J/kg °C. The specific latent heat of vaporisation is the energy needed to change 1 kg of water from liquid to steam with no change in temperature, so its unit is J/kg.
Turning 1 kg of water at 100 °C into steam needs about 540 times as much energy as raising the temperature of 1 kg of water by 1 °C (2 260 000 J compared with 4200 J). It is also more than 5 times the 420 000 J needed to heat 1 kg of water from 0 °C to 100 °C.

Explanation

A comparison needs similarities or differences between the two quantities, not a separate description of each. The key difference is that specific heat capacity is about changing temperature, while specific latent heat is about changing state at a constant temperature. Using the values to state how many times bigger one is shows the magnitude of the difference and lifts the answer to the top level.

Mark scheme
  1. 4 marks

    Levels of response (4 marks).
    Level 2 (3-4 marks): Scientifically relevant features are identified; the way(s) in which they are similar / different is made clear and (where appropriate) the magnitude of the similarity / difference is noted.
    Level 1 (1-2 marks): Relevant features are identified and differences noted.
    No relevant content: 0 marks.

    Indicative content (not a checklist; credit other valid points):
    Similarities
    - both are amounts of energy for 1 kg of water
    - both are given in joules per kilogram (specific heat capacity also per °C)
    - both describe energy that increases the internal energy of the water
    Differences
    - specific heat capacity is the energy needed to raise the temperature of 1 kg of water by 1 °C
    - specific latent heat of vaporisation is the energy needed to change 1 kg of water from liquid to vapour (steam)
    - specific heat capacity involves a change in temperature; latent heat involves a change of state with no change in temperature (at 100 °C)
    - units: J/kg °C compared with J/kg
    - specific heat capacity is used in ΔE = m c Δθ; specific latent heat is used in E = m L
    Magnitude
    - turning 1 kg of water at 100 °C into steam needs about 540 times as much energy as raising the temperature of 1 kg of water by 1 °C (2 260 000 ÷ 4200 = 538); allow 'the latent heat value is about 540 times bigger' as a magnitude point
    - boiling away 1 kg of water needs 2 260 000 J, more than 5 times the 420 000 J needed to heat 1 kg of water from 0 °C to 100 °C
    For Level 2, the answer must make clear what each quantity describes (at least one clear difference between them) and give a further similarity, difference or the magnitude of the difference. An answer that describes only one of the quantities stays in Level 1. Use best fit; full marks only if no incorrect statement contradicts a correct response (e.g. 'latent heat raises the temperature of the water').

Ready to try the rest? Every answer you write is marked against the mark scheme, so you can see exactly where the marks are.

Study Helper Hints first, answers after you try

Stuck on this one? Ask for a hint and I’ll point you in the right direction, without giving the answer away. Once you’ve checked your answer, I’ll show you how the marks are awarded.