Level:
Correct: 0
Incorrect: 0
Marks: 0/0

Penetration, contamination and irradiation

Practise 15 exam-style questions on Penetration, contamination and irradiation for OCR GCSE Combined Science (Physics Paper 12). Write your answer as you would in the exam and get it marked in seconds against the mark scheme, point by point, with the Study Helper on hand if you get stuck.

  • 15 questions
  • 1–6 marks each
  • Instant marking
  • No sign-up needed
15 questions, marked as you go

Sample questions with model answers

Here are 4 of the questions in this topic, each with a model answer, an explanation of why it earns the marks and the mark scheme an examiner would use.

Question 1

1 mark

Some emergency exit signs glow without using electricity. Each sign contains tritium, a radioactive gas, sealed inside glass tubes. Tritium emits beta particles of very low energy, which cannot pass through the glass.

When could one of these signs be a radiation hazard to people nearby?

Choose your answer.

  • A only if a tube breaks, because the escaping gas can be breathed in
  • B at all times, because the beta particles make the glass radioactive
  • C only in the dark, because the gas emits more radiation then
  • D at all times, because the glow from the sign is ionising radiation

Model answer

A (only if a tube breaks, because the escaping gas can be breathed in)

Explanation

The beta particles from tritium are so weakly penetrating that the glass absorbs them all, so an undamaged sign gives no radiation dose to people outside it. The hazard comes from contamination: if a tube breaks, the radioactive gas can be breathed in and then emits beta particles inside the body. Being irradiated never makes an object such as the glass radioactive, and radioactive decay does not depend on light or temperature.

Mark scheme
  1. 1 mark

    A / only if a tube breaks, because the escaping gas can be breathed in

    The only correct answer is A: the glass absorbs all of the low-energy beta particles, so an unbroken sign does not irradiate anyone outside it; if a tube breaks, the radioactive gas can be breathed in (contamination), and its beta particles are then emitted inside the body, next to living cells. B is not correct because irradiation by beta particles does not make the glass radioactive; C is not correct because the rate of radioactive decay is not affected by light or dark (the glow is only easier to see in the dark); D is not correct because the glow is visible light, which is not ionising radiation. ALLOW the letter or the option. If more than one option is given, do not award the mark.

Question 2

2 marks

Fruit flies damage fruit crops. In one method of control, millions of male fruit flies are made unable to breed by irradiating them while they are pupae, and they are then released. The pupae are packed in metal canisters about 10 cm across, which are placed next to a strong radioactive source.

Explain why a source of gamma rays is used rather than a source of beta particles.

Model answer

Gamma rays are very penetrating, so they pass through the metal canister and all 10 cm of pupae, and every pupa is irradiated. Beta particles would be absorbed by a few millimetres of metal, so they would be stopped by the canister wall (or the outer pupae), and the pupae inside would not be made sterile.

Explanation

The method only works if every pupa in the canister receives the radiation, so the radiation must pass through the metal wall and through many centimetres of pupae. Beta particles are absorbed by a few millimetres of aluminium or other metal; gamma rays are only reduced by thick lead or concrete. A common slip is to say beta particles are stopped by paper, which is true of alpha particles.

Mark scheme
  1. 1 mark

    gamma rays pass through the (metal) canister and through 10 cm of pupae / reach the pupae in the middle of the canister, so all the pupae are irradiated

    ALLOW gamma rays are (very / the most) penetrating, only if linked to reaching all of the pupae / the pupae inside the canister. IGNORE references to half-life or activity.

  2. 1 mark

    beta particles would be absorbed by the canister wall / by a few mm of metal / by the outer layer of pupae, so the pupae inside would not be irradiated (and could still breed)

    ALLOW beta particles are stopped by a few mm of aluminium / metal. ALLOW beta particles would not get through the canister. IGNORE beta particles are less ionising. DO NOT ALLOW beta particles are stopped by paper.

Question 3

3 marks

A scientist works with a powder that contains an isotope that emits only alpha particles. She handles the powder inside a sealed glove box. The box has walls of clear plastic 1 cm thick, and long rubber gloves sealed into holes in its front wall.

A colleague suggests replacing the plastic walls with lead glass 'to protect her from the radiation'.

Evaluate the colleague's suggestion.

Model answer

Alpha particles are the least penetrating radiation: they are stopped by paper or a few centimetres of air, so the 1 cm plastic walls and the rubber gloves already absorb all of them. Lead glass is used to reduce gamma rays, and this isotope emits none, so lead glass would not reduce her dose at all. The real hazard is contamination - breathing in, swallowing or touching the powder - and the sealed box already prevents that. So the suggestion would not make her any safer and would only add cost and weight.

Explanation

An evaluation needs a judgement backed by reasons. Here the reasons come from penetration (alpha particles cannot get through 1 cm of plastic, so extra shielding achieves nothing) and from the difference between irradiation and contamination (the glove box is there to keep the powder sealed in). A common error is to assume that lead always makes things safer, whatever the radiation.

Mark scheme
  1. 1 mark

    alpha particles are absorbed by the (1 cm of) plastic / by the rubber gloves / by a few cm of air, so no alpha particles pass through the walls

    1 mark for each of marking points 1-4, max 3. Max 2 if there is no judgement about the suggestion. ALLOW alpha particles are stopped by paper / skin, so they are already stopped by the plastic. DO NOT ALLOW alpha particles are stopped by a few mm of aluminium (that is beta) as the only reason.

  2. 1 mark

    so lead glass would not reduce the radiation reaching her any further / lead glass is needed only for gamma rays (and this isotope emits no gamma rays)

    ALLOW lead is used to reduce gamma rays, not alpha particles.

  3. 1 mark

    the main hazard is contamination: the sealed box (and gloves) already stop the powder getting onto her skin / being breathed in / being swallowed

    ALLOW the box is there to keep the radioactive powder inside / to stop it spreading. ALLOW alpha emitters are most dangerous inside the body, and the sealed box prevents this.

  4. 1 mark

    judgement: the suggestion is not needed / would not make her safer (and lead glass is more expensive / heavier)

    The judgement must be supported by at least one of marking points 1-3. ALLOW a judgement that changing the walls is a waste of money because the plastic already does the job. DO NOT ALLOW a judgement that the suggestion makes her safer.

Question 4

4 marks

A strong source of high-energy gamma rays is used in a room whose concrete walls are 80 cm thick. The room needs a door that reduces the gamma rays by at least as much as the walls do.

An engineer assumes that two materials reduce the gamma rays by the same amount if each square metre of them has the same mass.

Two doors are available:
• door P is made of lead and is 15 cm thick
• door Q is made of steel and is 25 cm thick.

Density of concrete = 2300 kg/m³
Density of lead = 11 300 kg/m³
Density of steel = 7800 kg/m³

Use the engineer's assumption to decide which door is suitable. Use calculations to help explain your answer.

Suggest why the door is made of metal rather than concrete.

Model answer

Take 1 m² of each.
Mass of 1 m² of concrete wall = density × volume = 2300 × (1 × 0.80) = 1840 kg
Mass of 1 m² of door P = 11 300 × 0.15 = 1695 kg
Mass of 1 m² of door Q = 7800 × 0.25 = 1950 kg

Door Q has more mass in each square metre than the wall (1950 kg compared with 1840 kg), so it reduces the gamma rays by at least as much as the wall: door Q is suitable. Door P has less (1695 kg), so it would let more gamma rays through than the wall, even though lead is the densest of the three materials.

The metals are much denser than concrete, so a metal door gives the same protection as the wall but is much thinner than 80 cm. A door about 25 cm thick fits in a doorway and can be slid or swung open, which an 80 cm slab of concrete could not easily do.

Explanation

Recall density = mass ÷ volume and use it to find the mass of each square metre: for an area of 1 m², the volume in m³ is the thickness in m. Under the engineer's assumption, a door needs at least 1840 kg in each square metre to match the wall. A common error is to choose the lead door because lead is the densest material: 15 cm of lead has less mass per square metre than 80 cm of concrete, so comparing only the densities, or only the thicknesses, does not answer the question.

Mark scheme
  1. 1 mark

    recall and use of density = mass ÷ volume: mass of each 1 m² of the concrete wall = 2300 × (1 × 0.80) = 1840 (kg)

    A choice of door with no working scores 0 for marking points 1, 2 and 3: the choice must be supported by calculation. ALLOW any area if it is used consistently for the wall and both doors (for example, for 2.0 m²: 3680 kg, 3390 kg and 3900 kg). ALLOW thicknesses in cm if they are used consistently (for example 2300 × 80 = 184 000). ALLOW the route through equivalent thicknesses of concrete for marking points 1 and 2: door P = 15 × 11 300 ÷ 2300 = 74 cm (73.7 cm) and door Q = 25 × 7800 ÷ 2300 = 85 cm (84.8 cm), compared with 80 cm. ALLOW the route through the least thickness needed for marking points 1 and 2: lead 80 × 2300 ÷ 11 300 = 16 cm (16.3 cm, more than 15 cm) and steel 80 × 2300 ÷ 7800 = 24 cm (23.6 cm, less than 25 cm).

  2. 1 mark

    mass of each 1 m² of door P = 11 300 × 0.15 = 1695 (kg) and of door Q = 7800 × 0.25 = 1950 (kg)

    Both values are needed for this mark. ALLOW 1700 kg for door P.

  3. 1 mark

    conclusion: door Q is suitable, because 1950 kg is more than 1840 kg, but door P is not, because 1695 kg is less than 1840 kg

    The conclusion must be supported by a comparison of values. ALLOW ECF from wrong values in marking points 1 and 2 if the conclusion follows correctly from them. DO NOT ALLOW door P chosen because lead is the densest material / is the best absorber of gamma rays.

  4. 1 mark

    suggestion: the metals are much denser than concrete, so a metal door that reduces the gamma rays as much as the wall is much thinner than 80 cm, so it fits in a doorway / can be moved to open and close / takes up less space

    ALLOW a concrete door would be too thick to open and close / to fit in a door frame. DO NOT ALLOW a metal door is lighter / a concrete door would be heavier (under the assumption, materials that give the same protection have the same mass for each square metre). IGNORE metals absorb gamma rays better, unless it is linked to a thinner door.

Ready to try the rest? Every answer you write is marked against the mark scheme, so you can see exactly where the marks are.

Study Helper Hints first, answers after you try

Stuck on this one? Ask for a hint and I’ll point you in the right direction, without giving the answer away. Once you’ve checked your answer, I’ll show you how the marks are awarded.